Back to home

POLYCO Recycling Pack Information Sheet

Recycling Pack

A practical recycling solution designed to help communities separate waste and turn recycling into everyday action.

POLYCO School & Recycling Pack Care Guide

Download the care & assembly guide (PDF)

What does a Recycling Pack look like?

The Recycling Pack brings together the parts needed for a clear, practical recycling station.

In one recycling pack, you will receive the following:

Two Station Recycling bins x 4

Bulk Bag Holders x 4

Bulk Bags x 4

Two Station Recycling bins:

Bulk Bag Holders:

How to assemble the bulk bag holder

Watch the demonstration below to see how the fold-flat holder is opened, secured, fitted with the recycling bag and folded away again.

Setting up the holder

Place the folded holder on a flat, stable surface with enough room to open all four sides.
Lift the upper frame and raise the hinged end and side panels until the holder forms a square, upright frame.
Square up the corners and connect each metal retaining hook to the matching eyelet on the adjoining panel.
Check that every corner is connected and that the holder stands evenly before fitting the bag.

How to hang the recycling bag

Open the bulk bag and lower it into the centre of the assembled holder.
Pull one sewn lifting loop up at each corner of the bag.
Place each lifting loop fully over the corresponding top corner support, as demonstrated in the video.
Make sure all four loops lie flat, are not twisted and carry the bag evenly.
Spread the mouth of the bag open inside the frame and confirm that no loop is trapped beneath a retaining hook.

Helpful note: The holder is easier to open and fit with the bag when two people work together. Keep hands clear of the folding hinges and corner connections during setup and pack-down.

Folding the holder away

Empty and remove the bag first. Lift the four loops off the corner supports, release the retaining hooks, fold the panels inward and lower the frame carefully into its flat storage position.